Amprobe AT-2005-A Advanced Wire Tracer Kit for Energized, De-energized and Open Wires

  • Rp.35,000,000

  • Availability:3-4 Weeks
  • Brand: Amprobe
  • Product Code: AT-2005-A


Tags: Cable & Pipe Locator


The Amprobe AT-2005-A Advanced Wire Tracer traces live wires buried or hidden behind walls up to 13 feet (4m) thick without interrupting power.

The AT2005A wire tracer includes a battery booster which strengthens signal for open tracing. The AT-2005-A is used for quickly locating breakers, broken wires, neutrals, grounds, shorts and pinpointing ground faults. Includes R2000, S2600-A, T2200, A2201, B2024, B2025.

R2000 Receiver

The R2000 receiver has two built in sensors that are tuned to pick up the 32.768khz signals generated by any of the transmitters in the AT-2000 family: S2600-A, T2200. The R2000 is designed to indicate the signal’s strength in audio and visual ways to enable precise location of the conductor carrying the signal.

S2600-A Load Signal Generators (LSG’s)

When connected to an energized circuit, the LSG’s will rapidly turn themselves on and off. This generates a slight, periodic current fluctuation that causes the power line to emit its own, trace-able signal. this signal can be detected all the way back to the main generator. However, the signal will not interfere with any sensitive electronic equipment and does not require power interruption.

S2600-A- For use on 9 to 300 volts AC or DC circuits only.

T2200 Transmitter

The T2200 injects a signal onto a conductor. This signal will travel to the end of a conductor. The T2200 transmitter is primarily used for finding breaks in hidden or buried conductors. It will also allow you to trace wires and locate shorts as long as the lines are non-energized.

A2201 Clamp-on transmitter Accessory

The A2201 will allow non-contact signal indication into energized or non-energized conductors. On energized lines, the signal will propagate downstream (from the source to the load) to the end of the circuit, provided there is current flowing in the circuit. Non-energized lines must be grounded at both ends or made into a complete circuit. The signal strength can be boosted significantly by using the B2024 (included) Battery Pack.

B2024 BATTERY PACK

24 Volt Nickel-Cadmium rechargeable cell custom designed for light weight, small size, and durability. Used to boost the output of the T2200 transmitter.

B2025 110V CONVERTER /RECHARGER

Can be used to either recharge the B2024 or directly boost the T2200.

Write a review

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha