Fluke 773 Milliamp Process Clamp Meter

Fluke 773 Milliamp Process Clamp Meter Details

The Fluke 773 is designed to let users measure 4 to 20mA signals without breaking the loop, saving time and effort when carrying out testing procedures.

This device is the best overall process clamp meter available from Fluke and includes a massive selection of advanced features designed to make your time spent testing as simple as possible. In addition to carrying out no-break-loop testing of 4 to 20mA signals this device can also measure 10 to 50mA signals in older control systems by using the 99.99mA range mode and it can also carry out in-circuit measurements, can be used to source signals for testing control systems (I/O and I/Ps) and much more.

This process clamp meter also includes a detachable clamp with extension cable for measurement in difficult, tight locations, can be used to source and measure VDC, can power a transmitter and includes a dual backlit display which shows both mA measurements and percent of 4 to 20mA span.

To aid with testing in darkened areas the Fluke 773 also includes a measurement spotlight for easy spotting hidden wires.

Fluke 773 Milliamp Process Clamp Meter Key Features

• Extremely high accuracy at 0.2%
• 0.01mA resolution and sensitivity
• Allows measurements of 4 to 20mA signals without breaking the loop
• Measures mA signals for PLC and control system analog I/O
• Dual backlit display shows mA measurements and percent of 4 to 20mA span
• Built-in measurement spotlight for illuminating darkened areas
• Detachable clamp with extension cable allows measurements in difficult applications
• Measure 10 to 50mA signals in older control systems using the 99.9mA range
• Automatically change 4 to 20mA output for remote testing procedures
• Auto off and backlight timeout extend battery life
• Data hold function
• Measure 4 to 20mA signals with in-circuit measurements
• Simultaneous mA in-circuit measurements with 24V loop power for powering and testing transmitters
• Source 4 to 20mA signals for testing control system I/O or I/Ps
• mA output linear ramp or 25% step output
• Carries out DC voltage measurements to verify 24V power supplies or voltage I/O signals
• Source DC voltage to test input devices that accept a 1-5V or 0 to 10V signals
• Scaled mA output
• Enables milliamp signal logging to separate logging device without breaking the loop

Full List of Products Included

• Fluke 773 Milliamp Process Clamp Meter
• 4 x AA Alkaline Batteries (Installed)
• Soft Carrying Case
• TL75 Test Leads
• AC 72 Detachable Clip
• TL 940 Mini Hook Test Leads
• Instruction Sheet
• Hanging Tool with Hook and Loop Strap