IDEAL Networks R156003 SignalTEK NT Network Transmission Tester

IDEAL Networks R156003 SignalTEK NT Network Transmission Tester

• Operates on both copper and fiber optic networks
• Gigabit performance testing on passive cabling and active networks
• Generates PDF test reports to IEEE 802.3ab standard
• Simulates VoIP/CCTV/Web/IP video network traffic
• Tests connection speed, port ID, ping, traceroute, IPv4/IPv6
• Supports IDEAL AnyWARE App

If you install, maintain or troubleshoot data cabling and Ethernet networks, SignalTEK NT allows you to prove the performance up to Gigabit Ethernet transmission rates. By simulating actual network traffic users are able to test and document network and data cable performance to Gigabit Ethernet standards. Where system warranties are not required the SignalTEK NT is a cost effective way of proving your copper and fiber networks provide error-free performance.

No calibration required plus

replaceable RJ45 contacts

Transmission testing proves real performance

There is no industry standard defining the testing requirements of cable qualifiers, consequently passing a qualification test does not prove that the installed structured cabling will provide flawless data transmission.

Uniquely, SignalTEK NT utilizes a test method known in wide area networks as transmission testing to prove the performance of a network by sending real Ethernet data frames through the cabling and/or network devices to compare the error rate against the IEEE802.3ab Gigabit Ethernet standard. This provides a clear standards based Pass/Fail of the link being tested.

SignalTEK NT requires no configuration from the user as the two handsets automatically pair ready for testing; just select a usage scenario to simulate the appropriate service, from VoIP to CCTV, Video, and web traffic.

Installation testing

Cabling:

• Network traffic performance test on copper and fiber to IEEE802.3ab standard
• Wiremap test for open, shorts, miswires and split pairs to TIA-568 standard
• Gigabit link verification for copper and fiber cabling

Active network:

• Network load testing through switches simulating CCTV/IPTV/VoIP/Web traffic
• PoE/PoE+ verification that displays available voltage at device location
• Check Ethernet connectivity at device location to 10/100/1000 Mb/s
• Verify network configuration (device IP/gateway address/subnet mask)
• Switch port identification via LLDP/CDP protocols

Troubleshooting/diagnostics

Cabling:

• Distance to fault using TDR technology (copper only)
• Ability to identify and trace cables with a compatible amplifier probe (62-164)
• Optical power indication (with compatible SFP modules)

Active network:

• Network load testing through switches simulating CCTV/IPTV/VoIP/Web traffic
• Stress test network before installing bandwidth hungry devices
• Port blink to visually trace cable from work area outlet to network switch
• Displays port ID of LLDP/CDP enabled switches to eliminate manual cable tracing
• Identify network connection problems as hardware, network or configuration faults
• Ping local network devices and Internet URL’s
• Count number of hops between network points with traceroute tests
• PoE load testing to confirm available power meets PoE device requirements

Features

• Provide proof of performance to your clients with PDF reports
• IDEAL AnyWARE app - Send reports from anywhere
• Network traffic performance test to IEEE802.3ab standard
• Cable tracing - Port blink to visually trace cables
• Displays port ID of LLDP/CDP - Eliminate manual cable tracing
• Copper cable testing - Wiremap and distance to fault using TDR
• Fiber cable testing - optical power indication. (SFPs required)
• PoE - Power over Ethernet verification with voltage.